Please use this identifier to cite or link to this item: https://hdl.handle.net/20.500.12544/682
Comparison of crustal thickening budget and shortening estimates in southern Peru (12–14°S): Implications for mass balance and rotations in the “Bolivian orocline”
May-2010
Geological Society of America Bulletin, v. 122, n. 5–6, 2010
Two fundamental questions of interest with regard to the Andean Plateau are the mass balance of material needed to create and sustain a 3–4-km-high plateau and the relationship between the plateau and the bending of the Bolivian orocline. The link between these two questions is the distribution of shortening through the Central Andes. Is crustal shortening sufficient to support an isostatically compensated 60–70-km-thick crust? Is differential shortening between the hinge of the orocline and its limbs sufficient to account for both physiographic curvature and measured rotations? Three-dimensional (3-D) models of deformation within curved orogens require, in addition to paleomagnetic data, viable two-dimensional estimates of displacements. To this end, we present new map data and use those data to derive estimates of shortening across the northern margin of the Andean Plateau. The cross-section extent, from the eastern edge of the volcanic arc to the foreland basin, is approximately one half of the physiographic width of the Andean Plateau in Peru. Cross-sectional shortening estimates in southern Peru (12–14°S) provide a preferred estimate of 123 km or 40% shortening, with a minimum estimate of 58 km or 25% shortening and maximum estimate of 333 km or 65% shortening. The largest controlling factor on the magnitude of shortening is where basement becomes involved in thrust belt deformation. Using our preferred shortening estimate, the differential shortening between our cross section on the northern margin of the Bolivian orocline (12–14°S) and cross sections across the axis of the Bolivian orocline (17–18°S) is 177 km, corresponding to 23° of rotation. The differential shortening for the young (younger than 15 Ma) deformation of the Altiplano and Subandean region between 12–14°S and 17–18°S is 88 km, correlating to 11.5° of rotation. While differential shortening can account for young (younger than 15 Ma) vertical-axis rotations, it cannot completely account for early 45–35 Ma rotations (37° ± 15°). This suggests that forearc rotations reflect both bending due to differential shortening, ~12°, as well as block rotations (~25°–30°), which facilitated deformation in a tightening core and transported material toward the center of the orocline. The preferred estimate of shortening is well short of the required 240–300 km of shortening needed to account for a 60–70-km-thick crust under the entire plateau. This suggests that for an isostatically equilibrated crust, either (1) there is a significant amount of shortening (~100–150 km) in the western half of the plateau that is hidden by the volcanic arc; or (2) crustal material is being added to the Peruvian section of the Andean Plateau, most likely through lower-crustal flow.
Geological Society of America
Gotberg, N.; McQuarrie, N. & Caillaux, V. C. (2010) - Comparison of crustal thickening budget and shortening estimates in southern Peru (12 14°S): Implications for mass balance and rotations in the “Bolivian orocline”. Geological Society of America Bulletin, 122(5–6): 727–742. Doi: 10.1130/B26477.1
pp. 727-742

Files in This Item:
There are no files associated with this item.


Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.